HobartWelders

Hobart 500546 Airforce 700i 230-Volt Plasma Cutter

Price:
Availability: Not Available - stock arriving soon
CERTAIN CONTENT THAT APPEARS ON THIS SITE COMES FROM AMAZON SERVICES LLC. THIS CONTENT IS PROVIDED 'AS IS' AND IS SUBJECT TO CHANGE OR REMOVAL AT ANY TIME.

Manufacturer Details

The Hobart Air Force 700i Plasma Cutter is an economical plasma cutting system for all conductive metals. It can cut mild steel up to 7/8in. This portable unit features a lightweight, powerful inverter design and an ergonomic trigger safety, with more efficient air consumption and economically priced consumables. Plasma cutters cut faster and more precise with a thinner kerf and less slag than cutting with oxy fuel. A smaller heat-affected zone also causes less warping. And you'll never have gas pressure settings, flame tuning, metal preheating, or gas cylinders or refills to worry about. Features Hobart's 5/3/1 industrial warranty protection. Plasma Gas Flow/Pressure: 4.8 CFM (136 L/min) at 90-120 PSI (621 - 827 kPA) recommended, Clamp Cable Length (ft.): 16 1/2, Cutting Thickness (in.): Up to 7/8in. mild steel, Power Cord (ft.): 10, Dimensions L x W x H (in.): 14 1/4 x 8 1/4 x 11 1/4, Duty Cycle: 50% @ 40A, Pilot Arc: Yes, Volts: 230, Cart: No, Amps: 40

Key Features

Cuts 3/8- to 5/8-inch steel if powered by an engine-driven welder with a 240-volt generator power outlet of 8,000 watts or more Designed for increased comfort, more efficient cooling, and economical replacement cutting tips Built to withstand tough working environments, rated for 35% duty cycle at 104 degrees Fahrenheit Provides peak performance power under variable input voltage conditions (+/-15%) for steady and cleaner ending cuts Post-flow air cooling cools the torch and tip after cutting, extending life of replaceable tip and electrode

Write a Review